Juicer

Model Number

Commercial Type - Medium / Max , Cracker

Commercial Type - Medium / Max , Commercial Type - Cracker
3-Step Pressure Extraction Doubles the squeeze!

Medium

Max

• Name : Angel Juice Extractor MIDIUM / MAX
• Model : AG 20000 / AG 30000
  
• Extracting Method : Twin Gear Triturating
• RPM : 60 rpm

Before operating the machine

Do not operate the machine with wet hands Do not use the machine at in a place with excessive moisture Unplug the Juice extractor from the electrical outlet when not in use, assembling, disassembling, cleaning, and removing food or other contents from the juicer (feeding chute) Avoid contact with moving parts while the machine is in operation Carefully read the instruction manual before operating

Operating Instruction

Do not operate the machine with wet hands Do not use the machine at in a place with excessive moisture Unplug the Juice extractor from the electrical outlet when not in use, assembling, disassembling, cleaning, and removing food or other contents from the juicer (feeding chute) Avoid contact with moving parts while the machine is in operation Carefully read the instruction manual before operating

How to disassemble & Clean the machine

Let the machine run for about one minute to get rid of excess feed/juice Press the "Stop" button and then switch the power lever to the "OFF" position Open the Electric Control Box and switch the Main Power Switch to the "OFF" position Close the Electric Control Box Unplug the Juice extractor from the electrical outlet before disassembling and cleaning Remove the housing cover Unscrew the butterfly nuts on both sides and release the latches
Remove the screen housing (in case the screen housing does not release easily, turn the power switch ON/OFF one or twice then it will be released smoothly) Remove the twin gears
Clean the screen housing with the cleaning brush under running water (do the same with the twin gears) Dry with clean towel and then air dry the parts

How to Assemble the Gears

First, Insert the Driving Gear through the Driving Gear Shaft. Please Note! Slowly slide the driving gear through the driving gear shaft, but do not push the gear fully into the slot at this time. Right before the gear is set into the end of the slot, wiggle and/or turn the gear and so it is securely aligned with the gear shaft. Then, push the gear fully into the slot. Make sure the gears are fully seated. Second, Insert the Free Wheel Gear through the Sub-Shaft. Always make sure the gears are fully seated before operating. If you forcefully push the gear all the way into the slot without properly aligning them, the gear shaft can get damaged. Slowly slide the screen housing over the twin gears and push it back. Firmly tighten (do not over tighten) the butterfly nuts and place the screen housing cover.